I am selling my spare PSI3 data monitor, it reads data from the OBD port below the dashboard, it can read fault codes, reset the ECU and with additional sensors it can display oil temperature and oil pressure.
You can also set warnings/alarms for various parameters (e.g. low oil pressure, high boost pressure etc.)
The parameters displayed are:
Boost pressure (BAR or PSI)
Intake air temperature (degrees C)
Coolant temperature (degrees C)
Engine speed (RPM)
Battery volts
Throttle position %
Road speed (mph or km/h)
Ingnition advance (degrees BTDC)
Air flow meter (g/s)
Lambda sensor (Lambda ratio or AFR)
Knock correction (degrees ingnition offset; good to know if your engine is knocking due to e.g. bad fuel)
Injector duration (milliseconds)
Exhaust gas temperature (additional sensors needed)
Time of day clock
Oil temperature (additional sensors needed)
Oil pressure (additional sensor needed)
This is the later version with the VFD display.
It comes with fitting instructions and the instruction manual.
It fits both Imprezas and Foresters.
350€
You can also set warnings/alarms for various parameters (e.g. low oil pressure, high boost pressure etc.)
The parameters displayed are:
Boost pressure (BAR or PSI)
Intake air temperature (degrees C)
Coolant temperature (degrees C)
Engine speed (RPM)
Battery volts
Throttle position %
Road speed (mph or km/h)
Ingnition advance (degrees BTDC)
Air flow meter (g/s)
Lambda sensor (Lambda ratio or AFR)
Knock correction (degrees ingnition offset; good to know if your engine is knocking due to e.g. bad fuel)
Injector duration (milliseconds)
Exhaust gas temperature (additional sensors needed)
Time of day clock
Oil temperature (additional sensors needed)
Oil pressure (additional sensor needed)
This is the later version with the VFD display.
It comes with fitting instructions and the instruction manual.
It fits both Imprezas and Foresters.
350€